PM-Series (2” Pad Mount) Series: Small case. Replaces Korean (Mando type) alternators using dual 2” static pad mounting feet. (Found on many Mercruiser and Volvo Penta gas engines.) Once you have determined that the new alternator is the correct replacement for your existing model: 1. Disconnect the batteries and/or turn the switch to the “OFF” setting. Disconnect the wiring from the existing alternator. 2. Loosen the mounting & tensioning bolts and remove the existing alternator. ….6. Connect the output cable (see cable sizing recommendations below) ground, field wire, stator (tach) wire if needed and other necessary wiring. Connect alternator to regulator wiring harness as indicated in wiring diagram included the alternator’s positive and ground cables should be sized according to the chart on Page 3. 7. If a new regulator is being installed along with the alternator, complete its wiring installation according to the instructions included with your regulator
