Short Description
The information contained in this TSB supersedes TSB No. T-SB-0332-08.
• Applicability has been updated to include 2009 – 2010 model year Highlander, 2010 model year Camry, Corolla, Matrix, Sequoia, Tundra, and 2009 model year Venza vehicles.
• The SST table has been updated with an illustration.
• The Notice in the Repair Procedure has been updated with a Figure and torque specification ranges to clarify SST usage.
TSB No. T-SB-0332-08 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before proceeding.
Website: www.toyotapart.com | Filesize: 208kb
No of Page(s): 4
Content
To prevent damage to the oil filter cap assembly, this procedure must be closely followed during oil filter replacement to avoid immediate and future oil filter serviceability concerns. The following engines are equipped with a plastic oil filter cap assembly:
• 1UR-FE (Tundra, Sequoia)
• 3UR-FE (Tundra, Sequoia, Land Cruiser)
• 2ZR-FE (Corolla, Matrix)
…
Repair Procedure
During oil filter replacement:
• Ensure that SST 09228-06500-02 or 09228-06501 is used to remove and install the oil filter cap — or damage to the cap may occur.
• Inspect the SST for any damage or distortion before use.
• Confirm that the SST is fully seated on the oil filter cap when removing/installing (see Figure 1).
…
Get the file Download here