Short Description
INSTALLATION
NOTE:
• Inflate the tires to the specified air pressure.
• The dampers for the left and right sides are different. The damper marked R goes on the right side; the damper marked L goes on the left side.
• These dampers are designed to be used exclusively with this model and should not be used with other models.
• These instructions show the left damper assembly being installed; the same procedure applies to installing the right damper assembly.
Website: techinfo.honda.com | Filesize: 294kb
No of Page(s): 9
Content
Removing the Front Damper
1. With the vehicle on a rack, remove all four wheels.
2. Remove the wheel sensor harness clip and the brake hose bracket from the damper. Do not disconnect the wheel sensor connector.
3. Remove the damper pinch bolts and self-locking nuts from the damper. Do not allow the knuckle to rotate too far outward. This may allow the inner CV joint bearing to unseat.
4. Turn the ignition switch ON (II), then turn on the wipers. Turn the ignition switch off when the wipers are near the A-pillars.
…
Get the file Download here