Short Description
The transmission fluid is full (correct level) and in good condition (not burnt), and
• There is a harsh shift from 1st to 2nd gear, and/or
• DTC P0745 (line pressure solenoid circuit) is stored,
Website: nissan.justanswer.com | Filesize: 229kb
No of Page(s): 8
Content
…
SERVICE PROCEDURE
1. Drain and remove the transmission oil pan.
• Refer to the AT section in the appropriate Service Manual (ESM) for oil pan removal instructions.
2. Locate the ground terminal for the line pressure solenoid.
3. Remove the bolt and small bracket holding the ground terminal.
IMPORTANT: Make sure the metal washer that sits on the rubber grommet doesn’t fall off.
4. Make sure the ground terminal will not pull completely off of the wire.
• Use moderate force to pull / push the wire in and out of the terminal (no more than 5 lbs of pull force).
a. If the terminal pulls completely off the wire with 5 lbs of pull force, replace the solenoid valve assembly (see Parts Information).
• Refer to the AT section of the appropriate Service Manual (ESM) for solenoid replacement.
• Skip to step 11.
b. If the terminal does not pull completely off of the wire, go to step 5 and continue with this procedure.
…
Get the file Download here