Short Description
Step 1 - Unpack QuickLIFT system and verify contents.
Remove all items from the packing tube. You should have the following before beginning:
* (1) Gas springs - Part No. RT-QL-200-5A
* (2) Threaded ball studs
* (4) Washers
* (2) Locking nuts
* (2) fender brackets and steel rivets
* Printed Color Instructions
Website: www.redlinetuning.com | Filesize: 3707kb
No of Page(s): 4
Content
Step 2 - Gather the required tools.
Please gather the following tools before you begin the installation:
* Power Drill
* 5/16″ & 3/16″ drill bits - SHARP and NEW!
* 13mm socket and socket wrench
* 1/2″ open end wrench
* Rivet gun
* hammer and center punch
Step 3 - Mark fender bracket centerline.
A. Gather masking tape, tape measure and a permanent marker.
B. Measure from the front corner of the fender as shown to right 10″ and place mark on the fender tape - use this line to place the bracket at the centerline of the ball stud at a later step.
…
Get the file Download here