Short Description
The purpose of this Service Bulletin is to provide information to assist you in the replacement of both oxygen (O2) sensors on affected 2001 GL1800/A models. Moisture in the exhaust can damage the O2 sensors. Also, the right O2 sensor coupler can become corroded which will result in a non-functioning sensor. A replacement kit that contains two new O2 sensors is needed to repair the problem. Only perform this procedure if the vehicle actually experiences an O2 sensor failure.
Website: www.ridersrally.com | Filesize: 136kb
No of Page(s): 2
Content
REPAIR PROCEDURE
1. Remove the top shelter (see page 2-10 in the Service Manual).
2. Remove the left and right O2 sensors from the exhaust pipes.
• You do not have to remove the exhaust pipes to remove the O2 sensors.
• Be sure to note the wire routing for proper reassembly.
3. Install the new O2 sensors and route the wires properly (see pages 1-33 and 1-34 in the 2001-Service Manual).
4. Connect the black 4P female coupler of the subharness kit to the wire harness side black 4P male coupler (for the left-side O2 sensor).
5. Connect the new left O2 sensor to the black 4P coupler on the sub-harness.
…
Get the file Download here