KAWASAKI PARTS & SERVICE MANUAL SUPREME LIQUID AND AIR COOLED

Short Description
Read this manual and all other manuals pertaining to the Supreme carefully as they have safety, operating, assembly and maintenance instructions. Failure to do so could result in personal injury or equipment damage. Keep manuals in a safe place after operator and maintenance personnel have read them. Right and left sides are from the operator’s seat, facing forward.

Website: www.smithco.com | Filesize: 5674kb
No of Page(s): 114

Content
…
SPEED BOSS (KAWASAKI LIQUID COOLED)
Speed Boss allows the machine to operate at a proper speed while raking sand traps on golf courses. This speed boss has been factory set at an average speed of 3-4 mph(5-6.5 kph). The Speed Boss will only limit the speed while the rake is lowered into the operating position. The speed setting may be adjusted by removing the Yoke(A) from the Limiting Arm(B). Then loosen Jam Nut by ball fitting and Adjustment Rod(C). Turn Ball Joint clockwise to make the machine operate slower or turn counter clockwise to go faster. Tighten jam nut. Connect ball joint to limiting arm. Check to make sure nothing is binding and test drive to check desired speed.
…
WHEEL ‘CREEP’ ADJUSTMENT (KAWASAKI LIQUID COOLED)
‘Creep’ is when engine is running and hydrostatic transmission is in neutral, but due to inadequate alignment, wheels still move. Do the following procedures to stop this motion.
1. Lift up and support machine so all wheels are off the ground and can turn freely.
2. At rear of machine, on top of the hydrostatic transmission is the shift arm (A). Loosen bolts (B).
3. With engine running move stop (C) so it moves shift arm (A) to center and wheel creep stops.
4. Tighten all fasteners and test by using foot pedal linkage to see that the “creep” is removed.
5. Turn engine off and lower machine
…

Get the file Download here