Short Description
Read these instructions carefully and thoroughly before beginning work. Before installing the accessory, carefully consider whether one possesses the necessary technical skills (you must know how to access the battery on your R1200C) and workshop tools to complete the installation properly. Otherwise, any BMW Motorcycle Retailer will be glad to install this accessory.
Website: www.ztechnik.com | Filesize: 841kb
No of Page(s): 8
Content
PRE-ASSEMBLE GAUGES
1. Insert the Wire Harness into the Gauge Bracket from below the gauge cups. The harness end with the lamp goes to the left, the harness end with five wires goes to the right. Figure 1.
2. Place a gauge sleeve on the clock side (left side) of the gauge bracket. Top of sleeve aligns as illustrated. Figure 2.
3. Connect the clock wires and light from the harness to the back of the clock. slide the clock into the gauge sleeve. Be certain your clock is aligned for correct reading after light bulb and wires are hooked up.
4. Use the nylon female screws to secure the gauge. (Hex Key Wrench 4mm) Tighten the female screws securely. Be careful, over tightening will strip the female screws. Figure 4.
5. Assemble the Rev Counter into sleeve and bracket and connect the wires to the wire harness by color. Figure 5.
…
Get the file Download here